Threaded Mode | Linear Mode

istech · 11-13-2008, 10:52 PM

Dear all,

Has anybody had experience on marine shaft repairs? On many such shafts they will run through a Cutlass style bearing. This usually runs on a sleeve be it brass or stainless steel. My question is:

Has anybody used Thermal Spray Coatings to repair these shaft sleeves? Or is it not cost effective over making a new sleeve and replacing/machining a new one?

If anybody out there would be wiling to share there experience in dealing with the shipyard/marine industry it would be greatly appreciated.

Dale Finnerty
Sales Consultant

Industrial Surface Technologies Inc.
Campbell River, BC, Canada

Office: 250-287-2291
Cell: 250-287-6234

email: dale@istech.ca
http://www.istech.ca

Possibly Related Threads...
Thread:		Author	Replies:	Views:	Last Post
	mechanical strenght of TSC vs industrial and marine paint	basakglkn	6	3,366	05-14-2012 03:44 PM Last Post: andrrewdamien
	Big Screw pumps repair	HVoilF	9	3,908	07-01-2011 01:58 PM Last Post: mleonardo
	Corrosion of Stainless in Marine Environment	Adamgnt	5	3,369	04-20-2010 03:36 PM Last Post: pulaunias
	Repair Pump Shaft on Base Material Nitronic50	Piyapong	1	936	03-03-2010 05:53 PM Last Post: djewell
	Repair Ni-Cr coating	vevecaz	4	1,556	12-22-2009 08:00 AM Last Post: k09
	Turbine high speed shaft RPM 6000 to be coating	iwan-sedaryawan	4	2,091	12-10-2009 03:46 PM Last Post: Gordon
	Repair to HD vertical pumps [split]	HVoilF	1	1,529	05-13-2009 03:25 AM Last Post: Gordon
	Marine Coating Applications	istech	2	2,321	11-20-2008 04:17 PM Last Post: drramc
	Making new thread in a shaft of Jumbo Roll	iwan-sedaryawan	1	3,480	08-22-2008 02:40 PM Last Post: Gordon
	Marine Diesel Engine Liner	mcg_pinsbushing	12	5,098	05-16-2008 05:00 PM Last Post: Gordon
	Diamalloy 1008 H.D. Crankshaft Repair	HVoilF	4	4,069	04-12-2008 11:08 AM Last Post: hvofhamid