[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]
Posted by Dr. Ram Chattopadhyay (70.112.83.48) on 17:40:04 15/11/04
In Reply to:Re: Flaws in stellite coatings posted by Paul Burkhardt
: The coating is Stellite #6, it is plasma arced onto stainless steel type 316.
: Would the fact that the machining involves an intermittent cut cause a problem? (This is machining an off-set cone profile onto the seat).
:Hi,
I suppose it is a plasma transferred arc process , which is the most widely used process for this application. Normally grinding is used in finishing operation of Stellite6 coating.
Ram Chattopadhyay
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
