[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]
Posted by Paul Burkhardt (207.206.58.254) on 14:35:56 15/11/04
In Reply to:Re: Flaws in stellite coatings posted by Gordon England
The coating is Stellite #6, it is plasma arced onto stainless steel type 316.
Would the fact that the machining involves an intermittent cut cause a problem? (This is machining an off-set cone profile onto the seat).
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
