F4 Gun+Tristar+muticoat+inconel 718+unmelted
07-20-2012, 07:32 AM, (This post was last modified: 12-18-2012, 03:29 AM by Bler.)
#1
F4 Gun+Tristar+muticoat+inconel 718+unmelted
Rolleyes Hi,all,
I have some trouble when develop Inconel 718,with F4 HBS gun+Tristar power source+Multicoat assembly:
1.always some unmelted particles about 40-60um.
2.As the limit of Tristar Power source ,the hydrogen value should always below 11NLPN,if not ,the nozzle would be damaged.

could you give me some suggestions?
BR!
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Inconel 625 Plasma Sprayed Compressor Cylinder (ID) demionkrishan 4 3,423 06-17-2019, 01:32 PM
Last Post: demionkrishan
  Hardness of Inconel 625 after ground demionkrishan 3 3,738 05-06-2018, 12:28 PM
Last Post: demionkrishan
  Inconel 625 or NiAl 95/5 Iwan Sedaryawan CA 2 4,181 09-25-2015, 10:21 AM
Last Post: Joris Kraak
  Loading of Barrel when spraying Inconel 625 Bob Weber 11 10,810 12-31-2014, 08:52 AM
Last Post: Bob Weber
  Reduce unmelted particles in Combustion Wire Spray Alberto Villalobos 8 9,008 05-19-2014, 07:21 PM
Last Post: KevinS
  Inconel 625 - JP5000 SDA 7 10,650 12-28-2011, 06:54 PM
Last Post: djewell
  Hardness of Inconel 625 Met.Eng. 2 12,702 08-29-2011, 09:32 AM
Last Post: Met.Eng.
  Inconel 625 coating on flange surface gops123 5 13,379 04-05-2011, 01:54 PM
Last Post: Stuart Milton
  Melting, unmelted AlSi Microstructure Amdry 2010 powder William 4 7,690 08-26-2010, 04:00 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd