How to apply a uniform coat on a cone pulley with 8 different diameters |

05-04-2015, 03:19 PM
(This post was last modified: 05-04-2015 04:16 PM by behzadsaberi.)
Post: #1 | |||

| |||

How to apply a uniform coat on a cone pulley with 8 different diameters
Hi forum
I recently coated a cone pulley with 8 different diameters. I adjust the transverse speed of gun proportional to each step diameters (reduce the transverse speed of gun by increasing the diameter) to ensure having same coat thickness in a single pass on every 8 step. But surprisingly I have found that for the equal numbers of passes, coating thickness increased by increasing the diameter. I guess that’s because of the difference in surface speeds for each 8 steps of cone pulley. My question is that how I can spray such a cone pulley to have the same thickness at final stage of coating for all diameters??? The coating conditions that i used: 1)Hp-HVOF 2)WC-10Co-4Cr 3)minimum diameter: 63.95mm & maximum diameter:166.02mm 4) rotation speed: 120 RPM regurds | |||

05-07-2015, 03:47 PM
Post: #2 | |||

| |||

RE: How to apply a uniform coat on a cone pulley with 8 different diameters
I would think adjusting the lateral speed as per the SFPM (circumference * rpm) - need to program the robot accordingly - maybe a difficult task as the width of each step would be very small i would guess....
(05-04-2015 03:19 PM)behzadsaberi Wrote: Hi forum | |||

05-09-2015, 01:39 PM
(This post was last modified: 05-09-2015 02:14 PM by CHI3.)
Post: #3 | |||

| |||

RE: How to apply a uniform coat on a cone pulley with 8 different diameters
hello and welcome
Each diameter has to have a different RPM and traverse speed to equal the same surface feet per minute. Dia X 3.14(Pi)=Circumference 2400"(surface inch per minute) / Circumference = Turntable RPM RPM X .120"(step per revaluation) = Robot traverse | |||

05-17-2015, 07:10 PM
Post: #4 | |||

| |||

RE: How to apply a uniform coat on a cone pulley with 8 different diameters
Shantanu & Chico thanks for your useful recommends
| |||

05-18-2015, 07:42 PM
(This post was last modified: 05-18-2015 07:43 PM by behzadsaberi.)
Post: #5 | |||

| |||

RE: How to apply a uniform coat on a cone pulley with 8 different diameters
(05-09-2015 01:39 PM)Chico Wrote: hello and welcome thanks for your complete response if I understood your comment I need a rotating table which could be programed simultaneously with robot that I don’t have it | |||

« Next Oldest | Next Newest » |

User(s) browsing this thread: 1 Guest(s)