Gordon England Surface Engineering Forum

comparative hardnesses

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Joe Diesendruck (200.171.167.185) on 00:40:14 25/05/06

Hello,
Would any good samaritan know to tell how to compare
an HRC 60 to the hardness of a rubi stone ?
I explain myself: suppose you had a surface of a machined rubi stone as opposed to the same in hardened stainless steel tretaed to HRC 60.
The surfaces are pretty small as you can already imagine.
Thanks in advance, Joe

Follow Ups:

Re: comparative hardnesses - Gordon England 02:28:33 25/05/06 (2)
- Re: comparative hardnesses - Joe Diesendruck 00:21:27 26/05/06 (1)
  - Re: comparative hardnesses - Gordon England 00:45:40 02/06/06 (0)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.