Posted by Chris (210.211.203.160) on 15:13:56 13/06/06
In Reply to: Re: Coating on Crankshaft posted by Wojciech
We have been using 13Cr Steel, but that gives an hardness in the
range of 40-45 Rc, here we require 50-55 Rc.
Any suggestions ?
Thanks & Regards,
Chris
Please go to the new
Surface Engineering Forum as this old message
board is a read only archive. Please copy and paste relevant
information or link to this page if you wish to reactivate this
thread on the new forum. 