Newbie Spray Question
01-25-2012, 07:15 PM,
Newbie Spray Question
I want to spray alum wire with a Metco 12 standard gearing with acet. I am spraying a pipe with a 58" OD that is 10ft long. I estimated the weight of required material to be about 30# if it was done perfect so I doubled the expected usage for error. My partner argues that it will be around 150# to complete the job. I used the Metco book as a guide but may be calculating it wrong. Any suggestions on what the total weight would be?
Thank You,
Aaron Boyce
01-27-2012, 05:52 PM,
RE: Newbie Spray Question
Hi Aaron, how thick is the coating?

Will the standard gearing work with Al wire?
Stephen James Booth
Indonesia WhatsApp +6281905603262

01-29-2012, 02:41 AM,
RE: Newbie Spray Question
(01-27-2012, 05:52 PM)Stephen Booth Wrote: Hi Aaron, how thick is the coating?

Will the standard gearing work with Al wire?

Hi All,

Yes, the standard gearing will work with 1/8" aluminum and the EC aircap. Aluminum runs at near the top speed of the standard gears and near the bottom end of the high speed gears, so you can use either one.


Jim Weber

Possibly Related Threads…
Thread Author Replies Views Last Post
  Question about literature of Thermal Spray m_e_guerra 0 891 10-13-2019, 03:49 AM
Last Post: m_e_guerra
  spray & fuse question Brent 5 7,050 06-04-2012, 02:41 PM
Last Post: djewell
  Newbie Spray Question PPSABoyce 3 3,653 01-29-2012, 02:49 AM
Last Post: Jim Weber
  question about powder reaction during plasma spray process greentree 3 5,354 03-13-2009, 05:09 PM
Last Post: Gordon

Users browsing this thread: 1 Guest(s)

Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd