Metco 308NS Abradable |
05-11-2016, 12:15 AM
Post: #1
| |||
| |||
Metco 308NS Abradable
Hello everyone.
Has anybody ever successfully sprayed Metco 308NS with Plasma? Im struggling to find parameters (even from Metco) We currently use Flame but use Plasma for everything else. Looking to consolidate everything to Plasma spray to reduce change over times Any assistance would be greatly appreciated All the best Kev | |||
05-15-2016, 12:45 PM
Post: #2
| |||
| |||
RE: Metco 308NS Abradable
Hi Kev
Yes of course you can spray with Aps, at low amps, I used to spray it with F4 gun, but depend of the specification you need to reach. Best regards Luigi | |||
05-16-2016, 02:08 AM
Post: #3
| |||
| |||
RE: Metco 308NS Abradable
Dont suppose you would have some parameters as a base line you would be wiling to share ?
| |||
05-17-2016, 11:12 PM
(This post was last modified: 05-17-2016 11:17 PM by loriolo.)
Post: #4
| |||
| |||
RE: Metco 308NS Abradable
Hi Kev
Of course I could, Here you are some parameters: Powder Ni 15% graphite Powder size -90 +30 Gun F4 Nozzle 6 Injector 1,8 / 90° / distance 6mm Current 346 Amp Argon 30 SLPM H2 1 SLPM Spreader/suction (twin powder feeder) NL/NL Feed rate 34 grams/minute Spray distance 146 mm Best regards Luigi | |||
05-17-2016, 11:20 PM
Post: #5
| |||
| |||
RE: Metco 308NS Abradable
Thanks very much for your help.
I shall let you know how we get on All the best Kev | |||
« Next Oldest | Next Newest » |
User(s) browsing this thread: 1 Guest(s)
