Gordon England Surface Engineering Forum

WC standards

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Tanya (217.12.205.66) on 12:44:59 19/05/06

Hi Tony
I believe K30 is 91% WC and 9% Co, with no Cr.
K701 WC with Cr and Co binder, also consider K801 WC with Ni binder. Both should give better corrosion resistance. Not sure how much wear and mechanical properties will be compromise though.
Regards Gordon
Hi Gordon,
you seem to know a lot about Tungsten Carbide :)
i need to compare two standards of WC grit - YG8 and K30 (which is better for hole saw tip)
would really appreciate if you could help :)
all the best,
Tanya

Follow Ups:

Re: WC standards - Gordon England 18:07:49 23/05/06 (0)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.