Posted by Gordon England (62.252.0.12) on 13:20:13 28/02/05
In Reply to:Spraying Mn powder using APS posted by Nilesh Patel
: Looking for spraying parameter to spray Mn powder. I have sulzer metco G3 gun.
:
: Thank you in advance.
: Nilesh
:
Have you asked Sulzer Metco?
If no parameters can be found, choose a typical parameter set from the spraying manual that is close to your material composition and particle size and use this as a starting point.
Regards Gordon
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.