Gordon England Surface Engineering Forum

Re: Metco 4E Metallizer

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Gordon England on July 22, 2003 at 13:16:43:

In Reply to: Metco 4E Metallizer posted by Greg Hansen on July 18, 2003 at 23:19:24:

: Is anyone familiar with the Metco 4E metallizing gun? I'm not familiar with the use of these but acquired one recently. Are they still in use?

Greg

This is a very old. It will still do a good job, but I doubt whether you will be able to find spare parts for it. Probably best polished up and mounted as a museum piece.

Regards Gordon

Follow Ups:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.