The gun we should use is .........
11-04-2008, 09:32 PM,
#1
The gun we should use is .........
We are going to spray TBC on land based industrial gas turbine transition piece(some people call it backet). The small end of the part is 6" wide. What kind of plasma gun do you use to spray TBC?
Reply
11-05-2008, 02:51 PM,
#2
RE: The gun we should use is .........
we use Taffa SG2086 stick torch 36in length
Reply
11-05-2008, 10:21 PM,
#3
RE: The gun we should use is .........
Thanks a lot, J_rock.
How is this gun works?
When you decided to use this gun, have you think about how much are you going to pay for the He?
The cost of He is three times of H2.
Reply
11-07-2008, 04:41 PM, (This post was last modified: 11-07-2008, 04:44 PM by Steph.)
#4
RE: The gun we should use is .........
(11-05-2008, 10:21 PM)derek Wrote: The cost of He is three times of H2.

You can use the gun with either gases. H2/HE.

How deep and how much travel is required? Not sure if a 36 inch extention would have enough energy to melt TBC and if it does it would be close to the top of it's limit...
Reply
11-07-2008, 07:08 PM,
#5
RE: The gun we should use is .........
I tried the H2 for SG100 gun, the hardware was easy to be burn.
H2 is not a good choice.
Reply
11-12-2008, 04:48 AM, (This post was last modified: 11-12-2008, 05:00 AM by Intel55.)
#6
RE: The gun we should use is .........
3MBT    
Reply
11-12-2008, 05:02 PM,
#7
RE: The gun we should use is .........
Thanks, Intel55.
Does this gun works well?
Reply
11-12-2008, 05:44 PM, (This post was last modified: 11-12-2008, 05:48 PM by Intel55.)
#8
RE: The gun we should use is .........
(11-12-2008, 05:02 PM)derek Wrote: Thanks, Intel55.
Does this gun works well?

Works like a champ and is used all day long 6 days a week at some places I know of who coat TP's. Ar/He.

The 3MBT above is a 40" version. You can get them in just about any length you want. Cost about $3400 for the 40".
Reply
11-12-2008, 09:04 PM,
#9
RE: The gun we should use is .........
Hi Intel55, can you contact me at dji@psm.com ?
Reply
11-12-2008, 09:16 PM,
#10
RE: The gun we should use is .........
(11-12-2008, 09:04 PM)derek Wrote: Hi Intel55, can you contact me at dji@psm.com ?

Derek I have sent you an email from my gmail address.
Reply




Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd