Amdry960+Metco73FNS-1 Sample issue
06-23-2008, 10:29 AM,
#1
Amdry960+Metco73FNS-1 Sample issue
Hello,Everyone
we had a part sprayed Amdry960 bondcoat and Metco73FNS-1 topcoat,we didn't spray the samples with the part. before spray the part,how to spray the test samples?spray the two powders seperately or A.960+M.73 together?it's from CFM56 parts.I think its necessary to spray the sample the same as to the part,but we have a confuse and I have no idea to get the right information from our immature system.Anyone could guide?thanks a lot!
Reply
06-23-2008, 01:37 PM,
#2
RE: Amdry960+Metco73FNS-1 Sample issue
Hi,

We are talking about GE CFM56 right? The GE Standard Practice Manual gives you guild lines on proving out your system and operators.

What we like to do is firstly approve the powder on a set up similar to that of the actual job, same nozzle distance, turn table speed etc and also attach a button to the job if applicable. For example if we were spraying a stator case we would attach a few buttons to the VSV holes.

I believe you can approve both powders in one test piece.

Jim
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Sample Failure demionkrishan 3 3,326 04-05-2018, 05:57 PM
Last Post: ThePlummer54
  sample polishing question WC Co CHI3 4 7,060 02-10-2014, 09:06 PM
Last Post: KevinS
Question Frequency of spraying the test sample joanwang 1 3,773 12-11-2012, 10:43 PM
Last Post: kschewe



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd