electronic arc spray
02-03-2014, 08:25 AM,
#1
electronic arc spray
what paramaters should I be running when electronic arc spray by hand?
Reply
02-16-2014, 03:35 AM,
#2
RE: electronic arc spray
parameters are different for each wire and type of machine
Reply
02-17-2014, 11:03 AM, (This post was last modified: 02-17-2014, 11:03 AM by selimalkoc.)
#3
RE: electronic arc spray
Electric arc spray is one of the oldest, most effective methods of thermal spray coating processes. Developed in the early 20th century, electric arc spray uses a low power arc as its heat/energy source. This arc results in a spray process that is economically efficient—very low levels of power are required for the process, and very little heat is transferred to the work piece. Electric arc sprays are, capable of spraying at rates up to 40 lbs. per hour and or higher, producing some of the fastest coating rates of any coating method gaining positive economic efficiencies...

------------------------------------------------------------------
selim can alkoç
Dr. selim can alkoc
Reply
02-25-2014, 02:30 PM,
#4
RE: electronic arc spray
many thanks, parameters for a sulzer 600 electric arc gun?

(02-17-2014, 11:03 AM)selimalkoc Wrote: Electric arc spray is one of the oldest, most effective methods of thermal spray coating processes. Developed in the early 20th century, electric arc spray uses a low power arc as its heat/energy source. This arc results in a spray process that is economically efficient—very low levels of power are required for the process, and very little heat is transferred to the work piece. Electric arc sprays are, capable of spraying at rates up to 40 lbs. per hour and or higher, producing some of the fastest coating rates of any coating method gaining positive economic efficiencies...

------------------------------------------------------------------
selim can alkoç
Dr. selim can alkoc

Reply
02-27-2014, 11:27 PM, (This post was last modified: 02-27-2014, 11:31 PM by loriolo.)
#5
RE: electronic arc spray
Hi JNTR
I do not know why everybody have time problem, and do not describe correctly what they want to know, and the complete name of the system the need notices, you must write the complete name of the system, I can presume that you are speaking about Osu Ecoarc 600, if it is the system, is a special system for zinc, zinc/Al, Aluminum and Al/Mg, and you have written the material name on the process selector, it automatically select the appropriate voltage for the wire selected.
Best regards
Luigi
Reply




Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd