zinc Metco 10E
07-03-2010, 08:29 PM, (This post was last modified: 07-05-2010, 10:14 PM by sebastiangt.)
#1
zinc Metco 10E
hello, I'm Sebastian from Argentina, I got a gun METCO 10e to start my small business, it is an old gun but for starters, I wanted to know if the gun works well for metallic zinc 10e?

greetings to all and this forum is very good
Reply
07-05-2010, 05:41 PM,
#2
RE: hello
Hi Sebastian

Sign0016 to the Surface Engineering Forum.

The 10E gun is good for general purpose spraying as it will spray most wires. If you plan on spraying a lot of zinc, aluminium and any other low melting point wires it might be advisable to change the gearing to high speed (replace standard countershaft gear "S" with "H" high speed version).
Reply
07-05-2010, 07:15 PM,
#3
RE: Metco 10E Gun (hello)
Hi Sebastian

Change your thread subject title to help with forum searches.
Reply
07-05-2010, 10:18 PM,
#4
RE: zinc Metco 10E
thanks gordon, and change the title right?

that air flow and pressure of need, approximately how many hp has to have the compressor
regards
Reply
07-06-2010, 01:50 AM,
#5
RE: zinc Metco 10E
Hi Sebastian

Quote:thanks gordon, and change the title right?

Yes, thank you. I must apologies for my last post "Change your thread subject title to help with forum searches". I drop a "d" Ashamed0002, I meant I had changed it, but your title change is good Smile.

Quote:that air flow and pressure of need, approximately how many hp has to have the compressor

Not sure of HP rating of compressor, but the gun by itself will require around 30 CFM (0.85 cubic metres per minute) of clean dry air at 65 psi (4.5 bar). The line pressure at the regulator should be 75 psi (5.2 bar) minimum with the gun running to allow for efficient regulation. If you are running grit blasting or other processes at the same time from the same air supply, you will need to calculate for this also. It is important that the air is free from oil and moisture, so an after-cooler and air cleaner units should be considered.
Reply
07-15-2010, 09:23 PM,
#6
RE: zinc Metco 10E
gordon thanks, this forum is very good for me that helps me a lot I'm learning

regards
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Zinc arc spray vs Zinc-rich silicate or epoxy paint KeDuan 1 3,629 04-23-2016, 06:05 AM
Last Post: Stephen Booth
  coating on zinc bath pot walls shantanu 2 3,893 07-03-2013, 10:47 AM
Last Post: plzc126330
  brass coating over zinc part reg., prabu 2 4,719 11-08-2011, 09:40 AM
Last Post: xeviarjekel
  about corrosion against zinc molten denghans 3 5,657 05-31-2011, 12:30 PM
Last Post: denghans
  A Problem about Zinc Coating joylinkwu 3 7,598 05-30-2008, 04:05 PM
Last Post: ThermalMan



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd