thikness of WC/12Co by HVOH
07-20-2013, 08:50 AM,
#1
thikness of WC/12Co by HVOH
Dear Friends
Hi
Which thickness of WC/12Co coating layer can we apply by HVOF (Jet Kote)? Is it possible to apply 2mm?
the same question about CrC.
If we need to reach 2mm coating for shaft, what can we do?

Best Regards
Reply
07-20-2013, 10:25 PM,
#2
RE: thikness of WC/12Co by HVOH
Hi ....
Usually Wc/12Co and CrC coating has a low tickness limit, at list you can spray not more than 0,8 mm (if more you can have to much residual stresses in tha coating), so I reccomend you to use a first layer of a low cost material as NiCr/ iron base, about 1,4 mm, and after the Wc/12Co final coating with 0,8 mm, so you have 0,2 grind overlayer .
Best regards
Luigi
Reply
07-25-2013, 01:33 PM,
#3
RE: thikness of WC/12Co by HVOH
Hi, typical coating thichnesses as most of gas fuel HVOF : 200 microns WC-Co and 300 micron CrC .
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  WC-12Co low hardness DanyGans 3 4,996 05-04-2018, 04:25 PM
Last Post: DanyGans
  HVOF 88 WC-12Co Cracking problem on wire drawing capstan Hector Monjardin 7 7,875 10-19-2016, 11:55 PM
Last Post: Hector Monjardin
  88WC-12Co HVOF coating H2 contact Hector Monjardin 1 3,926 10-18-2016, 01:22 PM
Last Post: Vadim Verlotski
  Cracks in WC-12Co coating fhyuan 4 7,151 07-26-2012, 04:09 PM
Last Post: fhyuan



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd