opening blocked cooling holes in Stage 1 gas turbine blades
03-05-2017, 06:21 PM,
#1
opening blocked cooling holes in Stage 1 gas turbine blades
opening blocked cooling holes in Stage 1 gas turbine blades
hi all,
anyone can share the way of opening blocked cooling holes
in turbine blades? usually, I am using air grinder with small filler wire
to remove blocked cooling holes ,which has blocked by mud or while grit blasting.

please let me know is there any machine or special method

Cheers, krishz
Reply
03-07-2017, 08:27 AM, (This post was last modified: 03-07-2017, 08:31 AM by loriolo.)
#2
RE: opening blocked cooling holes in Stage 1 gas turbine blades
Hi Krishz

See the answer done in your last post dated 02.24 as Demionkrishan
Best regards
Luigi
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Arc spray or HVOF for bearing of turbine generator shaft Youssef 0 1,005 06-15-2020, 06:08 AM
Last Post: Youssef
  Nitrogen Cooling Neufeld 2 1,550 08-20-2019, 11:40 AM
Last Post: loriolo
  Hardfacing shredder blades ?? RD.welding 1 1,918 06-26-2018, 08:07 AM
Last Post: velocity
  Part shrinkage after cooling down. Rage2371 5 2,502 06-14-2018, 09:42 PM
Last Post: KevGarty
  Gas Turbine Blades HVOF Coating masking demionkrishan 7 5,514 01-17-2018, 01:09 AM
Last Post: Taz
  opening blocked cooling holes in Stage 1 gas turbine blades demionkrishan 1 2,150 03-04-2017, 07:44 AM
Last Post: loriolo
  turbine blades and vanes HVOF appliaction anne 4 3,272 12-02-2016, 05:54 PM
Last Post: demionkrishan
  Reg: Cooling process. Dileep 2 3,462 10-16-2015, 01:05 AM
Last Post: Johnny_Blaze
  turbine rotor gland seal system, Stephen Booth 1 3,691 06-20-2015, 06:47 PM
Last Post: Johnny_Blaze
  pin holes on the surface of PTA overlay raviswanadha 0 2,289 06-21-2014, 04:04 PM
Last Post: raviswanadha
  hvof cooling kschewe 0 2,829 07-16-2012, 06:10 AM
Last Post: kschewe
  3MB gun air cooling Azraf Saip 1 3,230 10-21-2011, 09:15 PM
Last Post: LEN WOOD
  Cutting blades for paper industry Met.Eng. 8 6,899 10-18-2010, 10:00 PM
Last Post: Met.Eng.
  Turbine high speed shaft RPM 6000 to be coating iwan-sedaryawan 4 6,687 12-10-2009, 03:46 PM
Last Post: Gordon
  valve opening procedure sutech 7 8,751 11-12-2008, 05:46 AM
Last Post: Intel55



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd