opening blocked cooling holes in Stage 1 gas turbine blades
03-05-2017, 06:21 PM,
#1
opening blocked cooling holes in Stage 1 gas turbine blades
opening blocked cooling holes in Stage 1 gas turbine blades
hi all,
anyone can share the way of opening blocked cooling holes
in turbine blades? usually, I am using air grinder with small filler wire
to remove blocked cooling holes ,which has blocked by mud or while grit blasting.

please let me know is there any machine or special method

Cheers, krishz
Reply
03-07-2017, 08:27 AM, (This post was last modified: 03-07-2017, 08:31 AM by loriolo.)
#2
RE: opening blocked cooling holes in Stage 1 gas turbine blades
Hi Krishz

See the answer done in your last post dated 02.24 as Demionkrishan
Best regards
Luigi
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Arc spray or HVOF for bearing of turbine generator shaft Youssef 0 975 06-15-2020, 06:08 AM
Last Post: Youssef
  Nitrogen Cooling Neufeld 2 1,488 08-20-2019, 11:40 AM
Last Post: loriolo
  Hardfacing shredder blades ?? RD.welding 1 1,873 06-26-2018, 08:07 AM
Last Post: velocity
  Part shrinkage after cooling down. Rage2371 5 2,423 06-14-2018, 09:42 PM
Last Post: KevGarty
  Gas Turbine Blades HVOF Coating masking demionkrishan 7 5,435 01-17-2018, 01:09 AM
Last Post: Taz
  opening blocked cooling holes in Stage 1 gas turbine blades demionkrishan 1 2,103 03-04-2017, 07:44 AM
Last Post: loriolo
  turbine blades and vanes HVOF appliaction anne 4 3,218 12-02-2016, 05:54 PM
Last Post: demionkrishan
  Reg: Cooling process. Dileep 2 3,425 10-16-2015, 01:05 AM
Last Post: Johnny_Blaze
  turbine rotor gland seal system, Stephen Booth 1 3,637 06-20-2015, 06:47 PM
Last Post: Johnny_Blaze
  pin holes on the surface of PTA overlay raviswanadha 0 2,254 06-21-2014, 04:04 PM
Last Post: raviswanadha
  hvof cooling kschewe 0 2,794 07-16-2012, 06:10 AM
Last Post: kschewe
  3MB gun air cooling Azraf Saip 1 3,202 10-21-2011, 09:15 PM
Last Post: LEN WOOD
  Cutting blades for paper industry Met.Eng. 8 6,831 10-18-2010, 10:00 PM
Last Post: Met.Eng.
  Turbine high speed shaft RPM 6000 to be coating iwan-sedaryawan 4 6,632 12-10-2009, 03:46 PM
Last Post: Gordon
  valve opening procedure sutech 7 8,693 11-12-2008, 05:46 AM
Last Post: Intel55



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd