horizontal spraying on surface of circular parts.
10-11-2013, 07:17 AM, (This post was last modified: 10-11-2013, 07:43 AM by Eagleman.)
horizontal spraying on surface of circular parts.
Hi All,

Will there be any concern when spraying horizontally on surfaces of an circular parts? I have a project to spray on 100 pcs of circulars surface using HVOF.


10-14-2013, 03:13 PM,
RE: horizontal spraying on surface of circular parts.
The hard part of your project will be holding the parts stationary so they do not move. Your fixture must be at a lower height than the surface you are coating to avoid bridging. Otherwise, you will spray them just like any other flat pieces.

Possibly Related Threads…
Thread Author Replies Views Last Post
  Surface corrosion when HVOF spraying vcduramais 4 526 08-20-2021, 11:25 AM
Last Post: vcduramais
  Surface preparation before spraying HVOF minh_8888 4 8,177 06-20-2011, 12:18 PM
Last Post: Met.Eng.
  Thermal spraying copper parts DVB 6 9,451 03-19-2008, 04:50 PM
Last Post: Gordon
  Porous Machined Surface on Part Lower Inner Diameter on Inco 718 Coating Surface Alexangel1226 4 7,833 03-19-2008, 02:05 PM
Last Post: Gordon
  Spraying on nitriding surface Panf 6 9,030 06-26-2007, 03:56 PM
Last Post: Gordon
Question Surface engineering in aircraft parts Yves 1 6,178 10-12-2006, 04:37 PM
Last Post: Gordon

Users browsing this thread: 1 Guest(s)

Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd