Wire Flame spray and Twin Arc spraying
03-30-2015, 08:47 PM, (This post was last modified: 03-30-2015, 08:47 PM by wtaz.)
#1
Wire Flame spray and Twin Arc spraying
Hi
Can the experts tell me whether it's possible to lay the bond of Metco 405-1using the METCO type 4E gun combustion wire flame spray then put the top coat of 13%Cr using the twin arc spraying. Please assist
Reply
03-30-2015, 09:41 PM,
#2
RE: Wire Flame spray and Twin Arc spraying
Hi
the best solution and more economic, is to use Nickel/5% alluminum with arc spray system (about 68 MPa), bond strenght is higher, than 405 Flame sprayed (about 45 MPa), and then spray 13%cr with arc spray too, Ask a welding wire reseller near you for wires.
Regards, Luigi
Best regards
Luigi
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Staring procedure for 6p-II flame spray mgbaca1 0 401 01-23-2024, 08:11 PM
Last Post: mgbaca1
  Assembling a second-hand zinc flame spray setup? Gasket 6 1,858 01-22-2024, 12:09 PM
Last Post: MarkDattilo
  Flame spray parameters TurbineRepair 12 22,855 12-10-2022, 05:27 AM
Last Post: SakshiVerma
  Hvof spraying on top of arc spray velocity 7 5,415 07-04-2019, 06:03 PM
Last Post: velocity
  Twin Arc spray system ( request for your recommendation) demionkrishan 0 1,991 03-04-2019, 10:22 PM
Last Post: demionkrishan
  Oxy-fuel wire spray gun questions hje 5 4,573 01-26-2019, 05:58 PM
Last Post: plasmajet1990
  YSZ thermal Spraying by HVOF and Flame mgbaca1a 2 2,982 09-24-2018, 08:57 PM
Last Post: mgbaca1a
  Application advantages of flame wire vs arc wire velocity 1 2,567 07-03-2018, 09:53 AM
Last Post: Stephen Booth
  MO wire spray parameter for 3GF kim jong hun 2 3,394 04-29-2018, 01:00 PM
Last Post: kim jong hun
  Mo wire spraying Arturas 6 4,644 09-15-2017, 01:29 PM
Last Post: Arturas
  Propeller shaft repair by flame spray in the cones area Iwan Sedaryawan CA 1 3,350 12-09-2016, 04:56 AM
Last Post: Stephen Booth
  Flame spray guns 5P, 5PII, Type N Hector Monjardin 1 4,163 11-17-2016, 10:35 PM
Last Post: mgbaca
  Build up with Powder Flame Spray Met.Eng. 8 11,158 05-30-2016, 12:08 PM
Last Post: Gordon
  Flame spraying copper to aluminum Steamhammer 2 5,513 03-23-2015, 05:32 PM
Last Post: djewell
  Technology of Flame Spray -old and new Boris Eizner 0 3,546 01-29-2015, 10:04 AM
Last Post: Boris Eizner



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd