Tinning mill rolls
03-23-2013, 07:02 PM,
Tinning mill rolls
Hi all,

We just coated a couple of rolls running in acidic condition in a tinning mill with WOKA 3652 FC -100 microns thickness as a replacement for hard chrome plating

We left the rolls as sprayed with a surface Ra if 4-6 microns as desired by the customer

The roll runs in an acidic condition with acids and chemicals like stenos sulphate and chromium oxide

The coating failed within hours of operation with the customer stating a " peel off from the surface" issue

Please let me know if the acid may have caused the problem for the WC coating because if the porosity due to the surface roughness.....or if probably a WC 12Co or 17 Co would perform better....Or any other reason that may have caused the failure. The coating was carried out with OEM parameters on a standard blasted surface.


03-23-2013, 07:45 PM,
RE: Tinning mill rolls
Hi Shantau
I do not know tinning rolls, but for zinc-rolls they use to coating with Crome carbide sealed, without any problem
Best regards

Possibly Related Threads…
Thread Author Replies Views Last Post
  Reg: POT Stabilizer Rolls Dileep 0 778 04-16-2021, 07:33 AM
Last Post: Dileep
  Sink pot rolls sealant Danmarco 4 2,535 10-14-2019, 05:56 PM
Last Post: PTSchram
  Hvof on conductor rolls for electric tin lines Danmarco 4 3,195 11-16-2016, 03:37 PM
Last Post: shantanu
  continuous casting rolls Arturas 4 6,966 11-16-2016, 09:41 AM
Last Post: arlen.nurlan
  Steel Mill aplication arlen.nurlan 5 5,821 07-29-2010, 05:47 AM
Last Post: Jaydev
  coating on rolls Jaydev 9 7,078 05-01-2010, 11:27 AM
Last Post: Jaydev
  Babbitt Cement Mill Bearings Bagri 3 7,887 04-14-2008, 05:59 PM
Last Post: Vijay Deshpande
  Heavy plate mill roll Arturas 2 6,408 04-12-2008, 03:45 AM
Last Post: Stephen Booth
  Hot Rolling Mill Rolls Vijay Deshpande 3 7,260 02-20-2007, 09:33 PM
Last Post: bhellman

Users browsing this thread: 1 Guest(s)

Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd