TAFA 9000 Arc Spray
11-13-2016, 07:05 AM,
#1
TAFA 9000 Arc Spray
Hi,

My TAFA 9000 Arc Spray PLC Red Light indicator is Blinking on Prog E,anyone know what happen?

Where can I find for this PLC software?

Thanks
Reply
11-06-2018, 10:13 PM,
#2
RE: TAFA 9000 Arc Spray
My TAFA 9000 Arc Spray System has the same problem. Have you found a solution, and would you please share it with me? Thanks

Reply
11-09-2018, 08:55 PM,
#3
RE: TAFA 9000 Arc Spray
Hello,

This is typically caused when the PLC battery dies and the EPROM which stores the plc program loses it software.

PM me if you need any additional information to move forward.

Jim
Reply
11-12-2018, 09:12 PM,
#4
RE: TAFA 9000 Arc Spray
Hi Jim,
You are correct. The program has been lost.

Tried to PM you, but the feature did not work, and there were no activation instructions in the help document. Could you email me at duane-at-metalfusioninc.com ?

-Duane
Reply
11-20-2018, 01:59 PM, (This post was last modified: 11-20-2018, 02:02 PM by Stef1903.)
#5
RE: TAFA 9000 Arc Spray
Hi,
I have a problems with my Tafa 9935 CoArc System. Although the air has the necessary pressure (6.9 bar) and flow, the E-stop buttons are pulled out, the E-Stop button on the display is red and doesn't start. Three alarms appear on the display: "Master air solenoid valve fault" (the first), "Master servo fault" and "gun head low pressure fault". The system doesn't allow me to erase alarms. I have the warning: "Low battery - Real Time Clock". The battery has 3V, but has the blades glued on it and attached to an electronic circuit. It's more complicated I change it. There is someone to tell me what to do?

Thanks!

Stefan
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  TAFA 45 CT arc spray coating shantanu 1 6,054 08-13-2013, 12:36 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd