Shrink fitting of coated shafts using low temperatures
04-02-2007, 04:51 PM,
#1
Shrink fitting of coated shafts using low temperatures
Dear All,
what is the minimum temperature to which Arc sprayed shaft with 13% Chrome steel can be subjected while carrying out shrink fitting.
Will there be cracks due to change in properties? what is the best material for this appication
Regards
Vijay Deshpande
Reply
04-03-2007, 01:49 PM,
#2
RE: Shrink fitting of coated shafts using low temperatures
Hi Vijay

As far as I know, there should not be a problem with this as long as the coefficient of expansion properties of the coating and substrate are not too different.
Reply
04-15-2007, 08:03 AM,
#3
RE: Shrink fitting of coated shafts using low temperatures
Dear Vijay,
You can try with dry ice.Time for treatment shall depend on the dia. of shaft.
For theoretical calculations for optimum sub-zero temperture you need to use co-efficient of thermal expansion data in the low temperature range for the given material.
I would be careful about the surface preparation(Ra values),alignment during fitting etc, remembering the basics that the spray coat can crack or spall due to impact or bending or point load.
ram chattopadhyay
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Detection of Coated Surface ServiceTech 2 1,665 10-08-2018, 07:59 PM
Last Post: ServiceTech
  About service temperatures of two different Ni-Al coatings fhyuan 1 2,651 09-02-2015, 09:38 AM
Last Post: Vadim Verlotski
  Coating on shrink fit bearing journals shantanu 1 2,722 01-27-2014, 07:44 AM
Last Post: Vijay Deshpande
  HVOF SPRAY ON EN31 BEARING STEEL SHAFTS Zanitech 1 3,834 10-18-2013, 11:49 AM
Last Post: Stephen Booth
  Tungsten Carbide HVOF Coated Ball Valves grinding and Lapping constraints --- Reg sreenuvundela 4 9,915 07-29-2013, 09:04 AM
Last Post: Met.Eng.
  sealing gate valve WC coated problem ehsan 15 14,247 02-02-2011, 04:09 PM
Last Post: ehsan
  Hardness Test in TC coated surface Vishy 4 9,754 10-12-2009, 02:46 PM
Last Post: Gordon
  Black coated aluminum fin & Hydrophilic coated aluminum fin comparison Lumbantoruan 3 11,697 01-30-2009, 07:51 AM
Last Post: Lumbantoruan
  Can plasma be applied to coated substrates? Steph 4 6,436 10-10-2008, 06:25 PM
Last Post: Gordon
  TSA in Cryogenic Temperatures Cachube 5 6,790 10-26-2007, 06:36 AM
Last Post: Cachube
  Coated abrasives grading systems: FEPA, mesh, micron Rogier 3 15,311 06-29-2007, 04:20 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd