Question on Spreader and Suction Plate
04-23-2009, 05:35 AM, (This post was last modified: 04-23-2009, 05:37 AM by kc77.)
#1
Question on Spreader and Suction Plate
Hi all,

I would like to ask what's the physical difference between the L, NL and 601 Spreader and Suction plate in the hopper? I checked physically the 3 spreader plate and couldn't find any significant difference. Hence the question is, if there is no difference in the 3 type of spreader, then why different parameters called out for different kind of spreader?

Thanks and Regards,
kc77
Reply
04-23-2009, 03:45 PM,
#2
RE: Question on Spreader and Suction Plate
The difference is in the depth of the channel left between the spreader / exhauster and the metering disc.

The L(iquid) is -0.2mm of the metering disc groove height

The N(on) L(iquid) is +0.2mm of the groove height

The 601 (for Metco 601 powder or similar) leaves the largest channel of the three at +0.4mm

Very small dimensional differences admittedly, but crucial for the powder flow characteristics.
Simon Hiiemae
Sulzer Metco (UK) Ltd
01633 488 091
emailaddressisSimon.Hiiemae@Sulzer.com
Reply
04-25-2009, 12:28 PM,
#3
RE: Question on Spreader and Suction Plate
Hi SimonH

Sign0016 to the Surface Engineering Forum.

Very helpful, thanks Cheers
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
Lightbulb Plate Rolling / Roll bending Roller worn gerdogan 1 895 12-02-2022, 07:53 PM
Last Post: Vadim Verlotski
  suction or pressure grit blast machine? stvon 2 5,194 04-17-2014, 04:01 PM
Last Post: Met.Eng.
  About electrodeposition of Ni-Cr particle on steel plate Catherine 0 3,494 06-06-2013, 04:05 AM
Last Post: Catherine
  Heavy plate mill roll Arturas 2 7,718 04-12-2008, 03:45 AM
Last Post: Stephen Booth



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd