Question about metal stamping and TSC
10-26-2016, 11:10 PM,
#1
Question about metal stamping and TSC
Good day for all

Does any one have experience with metal stamping hidraulic??
What do you think about the possibility of made a coating in the broach part??
1300 Tons load, 41 inches diameter...

Some photos attached

Regards

Héctor Monjardin


Attached Files Thumbnail(s)
   
Reply
10-27-2016, 10:13 AM,
#2
RE: Question about metal stamping and TSC
Hello
Tehe is one company in Poland which makes coating on similar elements:
https://certech.com.pl/?lang=en
Best regards
Mareg Goral
Reply
11-07-2016, 04:17 PM,
#3
RE: Question about metal stamping and TSC
Hi Hector

I think that the only choice is a spray and fuse coating, if you want to use a thermal spray system, or otherwise I recommend a laser cladding coating, but in this case you have higher costs, all applications where there is a high working pressure, standard thermal spray coating could not have a good behavior
Best regards
Luigi
Reply




Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd