Punch Material
05-12-2008, 05:27 PM,
#1
Punch Material
We use a Existing Tool to puch a CRCA(MS) Sheet steel and now we are planning to redesign a TOOL which can punch a Stainless Steel.

So i recommended a A2 steel for it ...

Pls anyone can comment on this..or can u advice me differently

Thanks and Regards,
R.Rajesh
Reply
05-15-2008, 10:07 AM,
#2
RE: Punch Material
Hi Rajesh

Sign0016 to the Surface Engineering Forum.

A2 tool steel sounds about right, but I'm no expert on tool steel selection Ashamed0002 It would be interesting to hear of any alternative material suggestions and also coatings/surface modifications that could further improve performance.
Reply




Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd