Metco ALuminum SF wire speed
12-16-2010, 09:38 PM,
#1
Metco ALuminum SF wire speed
Optimum wire speed (ft. / min) of Metco Aluminum SF wire 1/8 inch.

Hi Gordonengeland
Would you please inform me what is the optimum wire speed (ft. / min) of Metco ALuminum SF wire 1/8 inch.
Reply
12-17-2010, 12:56 PM,
#2
RE: Metco ALuminum SF wire speed
Hi M.Naguib

Wire speed is normally set for the highest wire speed at which the wire melts off to a point without sputtering. For many wires, the optimum speed results in a melting tip position about 12 - 25mm in front of the air cap. The actual length will vary depending on wire and the desired coating fineness.

If you look at your spraying tables in the gun manual for your equipment, you will find the typical consumption in weight per hour. If you weigh a known length of wire you can then easily calculate the wire speed needed.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Robot speed & RL turn table calculation demionkrishan 9 12,077 05-12-2020, 07:32 PM
Last Post: Lemster68
  Surface speed Panf 24 54,384 02-03-2020, 09:31 AM
Last Post: DMan
  Want consumables for Metco 16E combustion wire system. Turbo Machinery 0 2,183 06-07-2019, 12:11 PM
Last Post: Turbo Machinery
  surface speed for HVOF coating process gito 8 6,205 05-03-2019, 01:08 PM
Last Post: Lemster68
  High Carbon Iron Based Wire proporties (Metco 8222) Met.Eng. 3 7,026 05-03-2014, 08:49 AM
Last Post: plasmajet1990
  Bonding for Wire Flame Spray using Aluminum pure wire iwan-sedaryawan 3 6,137 12-14-2012, 08:00 PM
Last Post: MichiganMan
  Separation in Wire spray (Metco 405) shabisyed 3 7,694 03-13-2012, 08:44 AM
Last Post: loriolo
  Metco 450/NiGr on Aluminum? brian_dev 2 5,965 07-01-2011, 12:06 AM
Last Post: Vijay Deshpande
  surface speed for HVOF Zhiguo 10 15,368 03-05-2011, 05:50 PM
Last Post: ServiceTech
  Metco Aluminum SF Hardness M.Naguib 1 7,272 01-19-2011, 05:00 PM
Last Post: Gordon
  Machining for Aluminum Bronze wire flame spray iwan-sedaryawan 3 8,394 01-12-2011, 11:47 AM
Last Post: iwan-sedaryawan
  The recommended surface speed M.Naguib 1 9,418 12-14-2010, 09:53 AM
Last Post: kschewe
  Optimum Travers speed Met.Eng. 4 7,399 10-09-2010, 01:37 PM
Last Post: Gordon
  Robot Speed ykang 4 8,451 02-17-2010, 03:09 AM
Last Post: LEN WOOD
  Turbine high speed shaft RPM 6000 to be coating iwan-sedaryawan 4 8,210 12-10-2009, 03:46 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd