Metco 308NS Abradable
05-11-2016, 12:15 AM,
#1
Metco 308NS Abradable
Hello everyone.

Has anybody ever successfully sprayed Metco 308NS with Plasma? Im struggling to find parameters (even from Metco)

We currently use Flame but use Plasma for everything else. Looking to consolidate everything to Plasma spray to reduce change over times

Any assistance would be greatly appreciated

All the best

Kev
Reply
05-15-2016, 12:45 PM,
#2
RE: Metco 308NS Abradable
Hi Kev
Yes of course you can spray with Aps, at low amps, I used to spray it with F4 gun, but depend of the specification you need to reach.
Best regards
Luigi
Reply
05-16-2016, 02:08 AM,
#3
RE: Metco 308NS Abradable
Dont suppose you would have some parameters as a base line you would be wiling to share ?
Reply
05-17-2016, 11:12 PM, (This post was last modified: 05-17-2016, 11:17 PM by loriolo.)
#4
RE: Metco 308NS Abradable
Hi Kev
Of course I could, Here you are some parameters:
Powder Ni 15% graphite
Powder size -90 +30
Gun F4
Nozzle 6
Injector 1,8 / 90° / distance 6mm
Current 346 Amp
Argon 30 SLPM
H2 1 SLPM
Spreader/suction (twin powder feeder) NL/NL
Feed rate 34 grams/minute
Spray distance 146 mm
Best regards
Luigi
Reply
05-17-2016, 11:20 PM,
#5
RE: Metco 308NS Abradable
Thanks very much for your help.

I shall let you know how we get on

All the best

Kev

Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Problem solved Metco™ 2042 - CoNiCrAlY-BN / Polyester Abradable CSchwie 5 8,300 06-01-2017, 09:03 AM
Last Post: Tribologist_CH
  How to determine the porosity level of Metco 320NS abradable coating? viewwer 6 5,142 11-23-2015, 09:57 AM
Last Post: Joris Kraak



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd