Hydraulic Piston rod
10-08-2019, 06:26 AM,
#1
Hydraulic Piston rod
Dear friends,
I have got a deep pitted and scoured ( about 4 mm in diameter) piston rod which is unable to salvage by HVOF coating. Customer need that desperately, can anyone suggest the best practice to rework on it?
will below mentioned practice will be fine? or need to change anything? could you guys please advise?

1. Pre machine and remove scoured mark
2. ARC Spray using 75B / 8400 -
3. Intermediate machining
4. grit blasting
5. Apply HVOF Chrome carbide 250-300 microns
6. Final grinding
7. Super polishing

Regards,
DK
Reply
10-13-2019, 02:12 AM, (This post was last modified: 10-13-2019, 02:29 AM by m_e_guerra.)
#2
RE: Hydraulic Piston rod
Hi DK

I don't know the hvof technology (i just know something about the theory of the process) but i'm operator of an Arc Spray machine...

But, if the diameter it's appropriate, the steps are correct (I don't know about step number 5) Check the temperature when you rebuild whit arc spray, and the last layer of surface coating should start 0.7-1mm below of the nominal diameter (for possible off-centering of the piece, mainly if it's manually metallized)

I wish you a lot of success
Reply
10-14-2019, 05:51 PM,
#3
RE: Hydraulic Piston rod
I had same issue before please check my old threads. You van find good advices there. It works.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  WC-Co+NiCrBSi Applying on hydraulic piston rod Met.Eng. 4 4,821 05-09-2016, 05:45 PM
Last Post: Vadim Verlotski
  replacing hard chrome coating on piston grisen 3 5,312 10-08-2015, 12:07 PM
Last Post: Guner
Information Hydraulic Shaft - Thermal Spray - Advice needed Jagdeep 2 5,130 10-09-2013, 07:16 PM
Last Post: shantanu
  Alumina coating on piston divanis 7 9,125 03-13-2012, 10:59 PM
Last Post: loriolo
  High Pressure Piston Rods HVOF coatings HVoilF 14 24,467 12-24-2011, 10:20 AM
Last Post: k09
  2500 HP Diesel Engine piston liner Met.Eng. 5 7,296 05-24-2011, 02:51 AM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd