HVOF on CAST IRON ROLL
09-29-2010, 05:15 AM,
#1
HVOF on CAST IRON ROLL
Dear Forum,
Recently we coated a dia 14" roll which is made of cast iron with Diamally 1008 using HVOF. The coating looked good but, when when approaching +50 micron level while grinding, spot peel-offs appeared. Close inspection(naked eye) indicates/looks like localized bonding problem.(random spot peel off)
Pretreatment: The roll was degreased, torch heated to 200'C and degreased again prior to blasting. No bond coat was applied and the build up was 0.8mm per side.
Any suggestion or precaution when coating cast iron material?
The chrome plating company which did the job previously had some issues with this roll where blackish spot were observed. is it carbon or graphite content of the material or oil which has been there which is not removed sufficiently.

Forum Experts, kindly assist.

Thank you
S.Guna
Reply
10-04-2010, 07:37 AM,
#2
RE: HVOF on CAST IRON ROLL
Hi Guna

I suspect it will be oil. I think you will need to heat part to higher temperature and for longer time.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
Star HVOF WCCo on Chilled Cast Iron(55HRC) tobjung 1 599 03-04-2021, 11:16 AM
Last Post: Vadim Verlotski
Shy HVOF Coating Calender Roll issues. Suggestion needed tobjung 1 578 02-10-2021, 02:03 PM
Last Post: Lemster68
  Good preparation for cast iron base material plzc126330 3 2,554 11-24-2016, 01:17 AM
Last Post: plzc126330
  Cast iron restoring sprayloud 1 2,082 04-11-2016, 12:54 AM
Last Post: aerotherm
  Cast iron powder or wire M.Naguib 4 4,749 12-08-2013, 12:14 AM
Last Post: kschewe
  ROLL CONDUCTOR (HVOF POWDER) ir_minja 1 3,843 10-04-2010, 07:27 AM
Last Post: Gordon
  PTA Powder Composition for Cast Iron Stephen Booth 2 4,670 11-30-2009, 12:05 PM
Last Post: drramc
  Fusing of cast iron Arturas 1 5,750 08-16-2006, 01:23 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd