Erosion due to drilling mud
05-29-2014, 10:09 AM,
#1
Erosion due to drilling mud
Hi all, I'm designing a part for a downhole drilling tool which will see very high fluid speeds, mostly of very erosive drilling muds. The spec calls for 30 to 60 m/s fluid speeds, but I'm dubious I can get a material & surface coating combination which will not erode at that. It's a complex geometry so hard to make in solid tungsten carbide. Does anyone know whether HVOF carbide spray will withstand these fluid speeds and if not, what speeds should I restrict it to? Or any alternative approaches I should consider?
Reply
05-29-2014, 07:07 PM,
#2
RE: Erosion due to drilling mud
Any material is going to erode when it goes down hole. High density coatings (HVOF or preferably HVAF) are going to provide the best protection. I have seen erosion tests on HVAF done at the low end of the range of your fluid speed, and the coatings performed well. However, if there is any way you can slow down the speed, of course you will get longer life.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  mud drilling equipments Jaydev 19 17,968 12-29-2021, 08:55 AM
Last Post: Stephen Booth
  Erosion Test of an Abradable Coating baaddin 3 4,978 02-11-2014, 07:32 AM
Last Post: baaddin
  fresh-water corrosion, pitting and erosion Met.Eng. 5 11,088 05-29-2011, 05:45 PM
Last Post: Gordon
  Erosion-corrosion issues in boiler applications sivakumar 1 5,687 05-04-2010, 08:40 PM
Last Post: MichiganMan
  Hot corrosion/erosion of metal Operator Mike 7 11,390 08-08-2009, 07:29 PM
Last Post: Gordon
  not re-drilling holes TurbineRepair 3 5,092 10-10-2008, 07:08 PM
Last Post: Gordon
  Bentonite Abradable-Erosion Testing gejohn 1 7,611 02-19-2008, 02:48 AM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd