Delamination
03-29-2008, 06:57 PM,
#1
Delamination
Hey All...

I am spraying an inside diameter of a 7.5" outside diameter seal with a thin wall 0.060" with metco 444 and am having problems with adhesion. Im confident with our powder feed rates, gases and preparation. What im not sure about is the proper RPM of the substrate and temperature control. We are also spraying into a shoulder so turbulance could be an issue.
Any suggestions?

New here so if there is further information needed please let me know.
Reply
03-31-2008, 09:57 AM,
#2
RE: Delamination
Hi bgmach

Sign0016 to the Surface Engineering Forum.

What is the equipment/process that you are using and the thickness of coating?

Improving ventilation/air flow around the spray area to remove dust and debris. Try not to use shorter spray distance/stand off than recommended and if anything use lower than recommended powder feed rates, particularly if you are using the high spray rate parameters. Usually, Metco 444 is a pretty tolerant with good thickness limitation/low stress and normally doesn't mind getting a bit hot (certainly more so than other coatings Big Grin).
Reply
04-04-2008, 02:49 PM,
#3
RE: Delamination
Dear Bgmach,
I have also observed this phenomena while coating on ID. This may be due to compressive stress build up which manifests in lamination problem. May be u have to control inerpass temperature.
Vijay Deshpande
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  T800 coating delamination alvliew 5 4,382 05-05-2017, 02:54 AM
Last Post: KevinS
  Thermal barrier delamination problem Hector Monjardin 2 3,528 09-25-2015, 11:05 AM
Last Post: Joris Kraak
  Coating delamination problem texnicar 13 9,021 07-07-2015, 10:37 PM
Last Post: Johnny_Blaze
  45VFNS Delamination Meeker77 2 3,313 05-24-2015, 05:46 PM
Last Post: Meeker77
  Delamination BatuhanCemreAyas 2 3,381 01-02-2014, 06:30 AM
Last Post: sprayjet
  delamination in the coating codep 3 5,648 05-15-2013, 05:04 PM
Last Post: Gordon
  delamination in general epilson 1 3,375 06-21-2011, 07:45 PM
Last Post: Gordon
  APS WC coating delamination brianf121 2 4,580 07-22-2010, 04:30 PM
Last Post: brianf121
  delamination of spray - fuse coating Arturas 10 11,161 04-01-2009, 05:13 PM
Last Post: Gordon
  Inco 718 complete delamination!! TurbineWorks 5 7,670 06-15-2008, 03:28 PM
Last Post: Gordon
  Delamination of Aluminium Polyester Coating fhyuan 1 8,237 01-27-2008, 08:19 PM
Last Post: Gordon
  Delamination in Polyester B50TF222 top coat gejohn 1 6,905 05-03-2007, 05:52 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd