Coating hardness
03-19-2008, 10:38 AM,
Coating hardness
Hi Everyone,

I was wondering if the members of this board could give me some advice about testing the hardness of a protective coating. I understand the basics of a durometer, but would ideally like to find a simple solution that is non destructive. The range of hardness that we get using a durometer is between 10 and 100 newtons, but most typically around 30 newtons. It is basically a combination of a layers of paint that we are trying to test. Any advice is greatly appreciated.


03-19-2008, 12:49 PM,
RE: Coating hardness
Hi Jimmy

Sign0016 to the Surface Engineering Forum.

Not much experience with testing paint films, but I know most hardness test methods use indentation or scratching, that is they will damage the paint coating. Not sure about pendulum hardness test method and Vickers or Knoop microhardness testing may minimise damage, but I doubt these methods will be suitable for you anyway.

The only thing I can think of, is the pencil test. OK the harder grade pencils will damage paint coatings, but you could use softer grade pencils as a "go or no go gauge". Select a pencil grade that does not damage the paint surface and represents the minimum acceptable hardness of your paint. When testing, paint that is not damaged will be above the minimum hardness and acceptable, paint that is damage will be rejected as being too soft. This is fine as long as you do not need to evaluate the maximum hardness or need numerical hardness values.

A few links:

(link dead) pencil hardness test

pendulum hardness test

(link dead)

Hope that helps Big Grin
03-24-2008, 10:21 PM,
RE: Coating hardness
hi jimmy
if you test hardness on a part of matal you don t use with same caracteristique of your pieces,may be you ll be fixed
good luck

Possibly Related Threads…
Thread Author Replies Views Last Post
Lightbulb Low hardness on AlTiN Coating Christian93 0 148 02-05-2021, 02:32 PM
Last Post: Christian93
  coating hardness using Hipojet 2700M air cooled JRB VIRANI 10 2,622 03-08-2020, 06:41 AM
Last Post: Stephen Booth
  Coating hardness conversion bhellman 7 35,892 02-18-2020, 10:13 PM
Last Post: Neufeld
  How to increase coating hardness Airbin 2 6,686 11-20-2013, 11:10 AM
Last Post: Airbin
  what's the effect of the spray energy to the coating's hardness? Spark 3 4,316 07-10-2013, 05:55 PM
Last Post: loriolo
  pencil hardness and tukon hardness test transit 6 16,635 10-04-2012, 02:15 PM
Last Post: bruisjem
  Hardness test of the metco 314ns coating sam xu 6 9,480 08-25-2011, 03:38 AM
Last Post: Gordon
Question coating hardness corelation volf 1 6,174 01-18-2007, 05:47 PM
Last Post: Gordon

Users browsing this thread: 1 Guest(s)

Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd