Clean a PH Meter
12-28-2012, 10:16 AM,
#1
Clean a PH Meter
Hello friends,

A pH meter is an electronic device measures pH, which is the acidity (acids) and alkalinity (bases), of substances. pH meters loose some of their accuracy with every use and need to be calibrated on a regular basis. Along with regular calibrating, the pH meter electrode needs to be cleaned between each use to prevent contamination of the substances being measured. pH meters are usually use glass probes that are submerged into the substances being measured. The probe uses ions to attract other ions in the substances. It needs to be cleaned after every use. At all times, the glass tip of the probe is stored in a tube filled with an acidic solution around pH 3. The probe must never be stored in distilled or deionized water for long because the water will remove ions from the probe through diffusion, which can degrade the probe and its measurements.

Regards
Steven Brooks


Reply
01-10-2013, 07:24 AM, (This post was last modified: 01-10-2013, 07:24 AM by TonyMccallum.)
#2
RE: Clean a PH Meter
Hi Friends,

Here are some tips for cleaning a pH meter.

1. Gather the equipment. Most of the items are available at chemical supply stores. Procure Kimwipes, which are a special tissue specifically made for cleaning pH meters. If you cannot find Kimwipes, try to find a similar product. Distilled or deionized water will work as a general cleaner. A generally used pH-electrode cleaning solution is 0.1M of hydrochloric acid (HCl) with a pH of 1, which is used to clean the probe more thoroughly approximately once a month.
2. Prepare the pH meter for measuring. Put rubber gloves on. Pour the substance being measured into one beaker. Pour distilled or deionized water into a second glass beaker. Pour the pH-electrode cleaning solution into a third beaker. Be sure that there is enough water and cleaning solution in each beaker to thoroughly cover and clean the glass probe.
3. Measure the substance's pH level. Take the pH meter electrode probe out of it storage solution, rinse it with distilled or deionized water and wipe it clean with a Kimwipe. Proceed to take the measurement of the substance's pH level.
4. Clean to pH meter's probe. Immediately after measuring the pH level of the substance, soak the probe in the beaker of pH-electrode cleaning solution for the approximately 30 minutes or more, depending on how thoroughly it needs to be cleaned. After that, rinse the probe with distilled or deionized water and blot the probe with a clean Kimwipe to absorb any remaining water.

Best Regards,
Tony Mccallum

Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  air clean factory kaiselin914 1 2,407 10-12-2017, 11:14 AM
Last Post: sugarbear123
  Convert Electrical Meter Readings to kWh StevenBrooks 0 11,419 12-25-2012, 06:20 AM
Last Post: StevenBrooks
  new clean factory kaiselin914 0 1,892 06-13-2011, 09:50 AM
Last Post: kaiselin914



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd