Calculate powder weight needed to spray surface area
11-05-2014, 03:21 PM, (This post was last modified: 11-06-2014, 08:02 AM by Zacadoom.)
Rolleyes  Calculate powder weight needed to spray surface area
I need to calculate powder usage to spray ball valves with 1350 VM powder using JP 5000 HVOF system.

The ball valves are 10, 8, 6 and ,75 inch in diameter.

The coating thickness needs to be 450 micron.

Is there some type of formula. its for a costing to quote a customer.

11-07-2014, 09:57 PM,
RE: Calculate powder weight needed to spray surface area
1. Calculate surface area (A = 4 X pi X r^2).
2. Calculate coating volume (V = Surface Area X coating thickness).
3. Calculate coating weight (W = Coating Volume X coating density).
4. Calculate powder weight (Wpowder = Wcoating / (DE X TE)) where DE is 40% (typical deposit efficiency of JP) and TE is a target efficiency factor (how much time the gun is pointed at the part divided by the total powder feeding time).
5. Multiply powder weight by powder cost to achieve powder cost.
11-10-2014, 02:58 PM,
RE: Calculate powder weight needed to spray surface area
Thank you DJ!

Possibly Related Threads…
Thread Author Replies Views Last Post
  Powder Coating for Surface Table achmadarifudinh 3 2,767 11-28-2017, 12:19 PM
Last Post: Artyom
  Info needed on Bond Strength for Thermal Spray powders hereticgame 1 2,462 10-10-2017, 11:39 AM
Last Post: Vadim Verlotski
  Propeller shaft repair by flame spray in the cones area Iwan Sedaryawan CA 1 2,254 12-09-2016, 04:56 AM
Last Post: Stephen Booth
  ARC spray on welded surface Vs parent material shantanu 5 5,256 11-04-2013, 08:03 PM
Last Post: shantanu
Information Hydraulic Shaft - Thermal Spray - Advice needed Jagdeep 2 4,244 10-09-2013, 07:16 PM
Last Post: shantanu
  Copper wire arc spray surface roughness operator 10 8,873 09-10-2013, 09:06 AM
Last Post: Esteban
  How to define amorphous area and crystalline area from XRD peak??? fahad03092 1 4,109 05-19-2012, 01:39 PM
Last Post: fahad03092
  Coating on bearing seating area raviswanadha 4 5,857 09-28-2011, 01:59 PM
Last Post: djewell
  How to thermal-spraying with very large area hustzc 3 5,058 08-25-2011, 01:21 PM
Last Post: LEN WOOD
  spray area and material loss basakglkn 3 5,649 04-28-2008, 12:48 PM
Last Post: Gordon
  Porous Machined Surface on Part Lower Inner Diameter on Inco 718 Coating Surface Alexangel1226 4 7,848 03-19-2008, 02:05 PM
Last Post: Gordon

Users browsing this thread: 1 Guest(s)

Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd