(10-27-2011, 02:49 PM)k09 Wrote: What roughness profile do you get with the brush?
Could you share details of the wheel brush?
Regards
K09
We got an average roughness Ra=16 microns, by using tyrolit wheel brush which doesn't leave any impurities in workpiece when brushing. It is important to say that we use this procedure after preheating, and it's giving a good results. But on the other hand , we've seen that many of you first start grit blasting, and after 30min preheating and so on...
Our results seem to be very good, maybe a bit better if we found even better wheel brush
Regards