After ball milling, is the powder particle size will be changed?
11-20-2012, 05:19 AM,
#1
After ball milling, is the powder particle size will be changed?
Dear all,

I have a question. I want mix Hydroxyapatite and Carbon nano tube powder.

I want to use ball milling.

If I put zirconia ball and choose medium speed and time 12h for ball milling, is it going to change my original powder particles a lot?
Reply
11-21-2012, 11:14 PM,
#2
RE: After ball milling, is the powder particle size will be changed?
I think that it depend of the frequencies do you use, any way, certainly you have a new powder, with unknown characteristics, whats the meaning for this operation, and what is the use, often there are powders been produced for many years and tested for a lot of years, and still are having granes distribution problems.
Best regards
Luigi
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
Pencil Ball Mill Shaft- Journal Bearing Area HVOF Coating Issue tobjung 0 1,074 02-02-2023, 06:44 PM
Last Post: tobjung
  Roughness and particle size hustzc 5 8,473 07-05-2018, 06:39 PM
Last Post: velocity
  Particle size distributin texnicar 2 4,138 03-04-2015, 07:43 AM
Last Post: texnicar
  Tungsten Carbide HVOF Coated Ball Valves grinding and Lapping constraints --- Reg sreenuvundela 4 11,890 07-29-2013, 09:04 AM
Last Post: Met.Eng.
  About electrodeposition of Ni-Cr particle on steel plate Catherine 0 3,490 06-06-2013, 04:05 AM
Last Post: Catherine
  WC-Co by HVOF on Monel Ball valve raviswanadha 4 6,723 10-15-2012, 12:03 PM
Last Post: raviswanadha
Shy Grit size sam xu 3 6,691 03-23-2012, 04:24 PM
Last Post: sam xu
  Loose Particle of Flame Coat operator 6 8,463 12-26-2011, 02:11 PM
Last Post: plasmajet1990
  How to decide grit size ? bepsi 6 17,211 04-29-2011, 05:56 AM
Last Post: wilfred1963
  Ash Particle Hardness and Effect on Material Operator Mike 1 6,135 08-08-2009, 07:47 PM
Last Post: Gordon
  Molten Particle Temperature powerman 3 7,603 05-12-2008, 04:45 PM
Last Post: Intel55
  Pore size in carbides Jeff 5 8,797 12-04-2007, 04:39 PM
Last Post: Gordon
Question How to read a Media Size vs. Intensity chart gejohn 2 10,099 02-15-2007, 06:12 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd