95/5 Bond Strength
06-01-2010, 03:28 PM,
#1
95/5 Bond Strength
Hello to Group. Does anyone know the bond strength of Plasma 95/5 Nickel Aluminide over a machined surface of the same material? We are building up thrust faces on bearing holders and remachining before installing alumina ceramic for electrical insulation. Thank You.
Reply
06-02-2010, 09:33 AM,
#2
RE: 95/5 Bond Strength
Hi George

Sign0016 to the Surface Engineering Forum.

I have not seen any bond strength values for this scenario. But, I think it would probably be more than adequate for your purpose if done with care. Just make sure that the machined restorative coating is not contaminated with any cutting fluids and carefully grit blasted prior to coating. Though, I doubt the bond between NiAl/NiAl will be as good as with a normal substrate, chances are it will still be above that of the NiAl/ceramic interface bond strength. I think to be sure, do your own tests on complete coating system and if failure occurs at NiAl/ceramic interface or in ceramic, there should not be a problem.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Info needed on Bond Strength for Thermal Spray powders hereticgame 1 1,860 10-10-2017, 11:39 AM
Last Post: Vadim Verlotski
  95Ni 5Al bond strength alaskangrown 1 2,357 01-15-2016, 05:09 PM
Last Post: loriolo
  HVOF T800 Tensile Bond Strength issue wgg237 2 3,794 03-05-2015, 01:52 AM
Last Post: wgg237
Shocked Hard Crome Plating Bond strength Met.Eng. 4 5,454 02-24-2015, 02:37 AM
Last Post: Simon Kim
  Arc Wire Spraying Bond Strength wtaz 4 4,372 12-04-2014, 12:02 AM
Last Post: wtaz
  Abradable Coating-Bond Strength rayudugirish 9 11,201 01-06-2014, 09:55 PM
Last Post: derek
  Question on bond strength. Ghostwheel 4 4,437 10-13-2012, 10:03 AM
Last Post: kschewe
  Suggest on coating bond strength tester feifei0609 3 4,120 08-14-2012, 03:10 PM
Last Post: feifei0609
  Surface preparation and its effect on fatigue life and bond strength WMW 4 6,913 06-29-2010, 08:41 AM
Last Post: drramc
Question Bond strength of Arc Sprayed Coating sumant 3 9,497 07-31-2008, 12:54 PM
Last Post: LEN WOOD
  tensile bond strength and met examination TurbineRepair 7 8,032 07-23-2008, 03:33 PM
Last Post: TurbineRepair
  Bond strength abhalla 2 8,745 07-19-2006, 07:10 AM
Last Post: Madila Awalini



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd