Posted by Gordon England (62.252.0.12) on 21:49:22 02/06/06
In Reply to: Re: key process variables for APS posted by becky
Hi Becky
I would first choose voltage readings. On most modern constant
current power supplies, voltage is dictated by the resistance of
the plasma gases and nozzle/electrode geometry. Voltage is not
normally a set parameter (assuming plasma gas flows are the
primary setting). Voltage readings straying from normal range
will indicate problems (nozzle/electrode wear, water/gas leaks,
plasma gas flow problems).
Next would be powder feed rate and then gas flow rates
(including carrier gas).
Best regards Gordon
Introducing
Nature of Thermal Spray Coatings
Surface Engineering in a Nutshell
Surface Engineering Forum
Thermal Spray Gun Repair Service
Plasma Consumable Parts
Thermal Spray Powder Supplies
Applications:
Thermal Spray Coatings on Carbon and Glass Fibre Reinforced Polymers
HVOF Coating of Paper Making Roll
Abradable Coatings
Thermal Spray Processes:
Combustion Wire Thermal Spray Process
Combustion Powder Thermal Spray Process
Arc Wire Thermal Spray Process
Plasma Thermal Spray Process
HVOF Thermal Spray Process
HVAF Thermal Spray Process
Detonation Thermal Spray Process
Plasma Flame Theory
Cold Spray Coating Process
Wear and Use of Thermal Spray Coatings
Corrosion and Use of Thermal Spray Coatings
Glossary of Thermal Spray and Surface Engineering Terms
Image Directory for Thermal Spray Coatings
Plasma Gas Flow Information
Plasma Gas Flow Correction Calculator
Contact Form
Links to other interesting sites related to thermal spray and surface engineering
Reciprocal Links
Periodic Table of the Elements
SI Units
Calculators for Conversion between Units of Measurement
Hardness Testing
Surface Engineering Message Board Archive
Surface Engineering Message Board Archive Index
Photography Gallery2
Photography Gallery3
© Copyright Gordon England