hi gúy. im new here!!
06-05-2019, 02:47 AM,
#1
hi gúy. im new here!!
Hi Folks,

I know this is unheard of but thought I would put it out there.

Has anyone ever successfully sprayed over machined thermal spray? In particular Babbitt?

We have a job that has had a very thick build up of Babbitt but there was an area which did not clean up fully (due to poor communication from customer). If we have to re-do the entire job it would be thousands of dollars so hoping there is a way to "Top up" the previously sprayed/machined coating.

Perhaps machine a band then apply bond coat?

Any thoughts would be greatly appreciated
Nice to know you all
Reply
06-05-2019, 12:15 PM,
#2
RE: hi gúy. im new here!!
Strange.....I recall posting a very similar question a while ago. VERY Similar Big Grin


Attached Files Thumbnail(s)
   
Reply




Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd