brass coating over zinc part reg.,
11-02-2011, 05:01 AM,
#1
brass coating over zinc part reg.,
Hi,
Iam looking for some suggestion from experts, that Iam planning to produce a component in zinc (a pump part weighs about 200 gms) using pressure die casting process and to conceal the same using brass coating. Our ideas is to ease the PDC process(zinc part instead of brass part and to coat brass over the zinc part). My querries are;
1) What are all the types of coating available for coating brass over a zinc component effectively?
1) What should be the coating thickness required?
2) Is it possible to coat, thickness over 0.5mm?
3) If so, will the coating layer retain in the component during rotating?, say pealoff etc.,
Thanks
Prabu
Reply
11-07-2011, 07:43 PM,
#2
RE: brass coating over zinc part reg.,
1. It is possible to apply a brass coating over zinc using many techniques including arc spray, flame spray, HVAF, etc.
2. The required coating thickness is whatever you want it to be. If you have a wear tolerance, then the coating should be slightly thicker than that.
3. It is possible to apply thicker than 0.5 mm.
4. If the coating was applied properly, and the surface was well prepared before coating, then the coating should not peel off. You can grind the coating to achieve the surface roughness you require and to change the dimensions as you need them.
Reply
11-08-2011, 09:40 AM,
#3
RE: brass coating over zinc part reg.,
Brass and zink alloy are corrosive prone.
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
  Part shrinkage after cooling down. Rage2371 5 3,753 06-14-2018, 09:42 PM
Last Post: KevGarty
  Protective coating for the brass (CZ121) RobertW 0 2,004 11-22-2016, 02:29 AM
Last Post: RobertW
  Zinc arc spray vs Zinc-rich silicate or epoxy paint KeDuan 1 3,630 04-23-2016, 06:05 AM
Last Post: Stephen Booth
  coating on zinc bath pot walls shantanu 2 3,894 07-03-2013, 10:47 AM
Last Post: plzc126330
  about corrosion against zinc molten denghans 3 5,657 05-31-2011, 12:30 PM
Last Post: denghans
  zinc Metco 10E sebastiangt 5 7,092 07-15-2010, 09:23 PM
Last Post: sebastiangt
  A Problem about Zinc Coating joylinkwu 3 7,598 05-30-2008, 04:05 PM
Last Post: ThermalMan
  Porous Machined Surface on Part Lower Inner Diameter on Inco 718 Coating Surface Alexangel1226 4 8,982 03-19-2008, 02:05 PM
Last Post: Gordon



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd