Surface Engineering Forum

  • Alternative Forum Home PageSEF Portal
  • Old S E Message Board ArchivesOld Message Board Archives
  • Search
  • Member List
  • Calendar
  • Help

Current time: 02-22-2019, 04:06 PM Hello There, Guest! (Login — Register)


Surface Engineering Forum / General Discussion / Testing and Trashing / Introduction of Automobile Intake Manifold




Post Reply 
Threaded Mode | Linear Mode
Introduction of Automobile Intake Manifold
11-22-2018, 08:16 AM
Post: #1
Virgo Offline
Active Member
****
Posts: 47
Joined: Sep 2018
Reputation: 0
Introduction of Automobile Intake Manifold
The intake manifold is located between the throttle and the engine intake valve. It is called manifold because after air enters the throttle, the air passage diverges after pipe buffer. For the number of engine cylinders, such as four-cylinder engine and five-cylinder engine, air is introduced into each cylinder separately for natural intake engine. Because the intake manifold is located behind the throttle, when the engine throttle opens small, the cylinder can not absorb enough air, which will cause high manifold vacuum; and when the engine throttle opens large, the vacuum in the intake manifold will become smaller. Therefore, the fuel injection engine will be equipped with a pressure gauge on the intake manifold to supply ECU (Elec control unit, also known as "driving computer", "on-board computer" and so on. In terms of use, it is a special computer controller for automobiles, also known as a special single-chip computer for automobiles. The function of electronic control unit is to calculate, process and judge the input information of air flowmeter and various sensors according to its memory program and data, and then output instructions to provide a certain width of electric pulse signal to the injector to control the injection quantity. The electronic control unit consists of a microcomputer, input, output and control circuits, etc.) to determine the engine load, and to give an appropriate amount of fuel injection.
Flying dragon intake manifold needs a series of processes from development to finished product. The process is also very mature.
Send this user an email Find all posts by this user
Quote this message in a reply
« Next Oldest | Next Newest »
Post Reply 




Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  Cast iron for automobile parts Virgo 0 93 12-13-2018
09:31 AM
Last Post: Virgo
  Breakthrough in Hydrogen Fuel Production Technology and Innovation in Automobile Indu Virgo 0 81 12-12-2018
07:22 AM
Last Post: Virgo
  Cast iron for automobile parts Virgo 0 87 12-07-2018
07:37 AM
Last Post: Virgo

  • View a Printable Version
  • Send this Thread to a Friend
  • Subscribe to this thread


User(s) browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd

    Subscribe in a reader

    Contact Us | Thermal Spray Coatings | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication

Powered By MyBB, © 2002-2019 MyBB Group.


© Copyright Gordon England