Heavy plate mill roll
04-10-2008, 05:22 PM,
#1
Heavy plate mill roll
Hello,
Maybe it is impossible, but I am trying to spray and after fuse self fluxing coating on the roll which length 5000mm, diameter 450mm and weight 5000kg Happy0193 , but there is only one problem Ashamed0002 I don't know this material WC/Co/NiCrBSi really is suitable or not in this conditions ? I know that all such kind rolls which perform transporting of plates repair using welding processes. Rolls transport plates (temperature of plate from 600-800C) width up to 3 meters, length up to 10 meters and thickness from 10 to 200mm.
Thank you and waiting replay
Best regards
Arturas
Reply
04-11-2008, 01:03 PM,
#2
RE: Heavy plate mill roll
Dear Artruras,
I am really interested to know about the set up required to carry out spray and fuse application on such a huge roll.
Regards
Vijay Deshpande
Reply
04-12-2008, 03:45 AM,
#3
RE: Heavy plate mill roll
I have seen this done, and even attempted some our selves with limited success. Years ago, about 20 years back, a company in Germany Gustav Weigen, if not mistaken was using Spray Fuse with Hardness of 60 HRc on similar parts.

We made a jig locally to do this type of application, which consisted of 8 fusing torches mounted in a ring traversing along the part. It is the same as fusing a small part, just bigger and incredibly dangerous. Would be easier to buy a plasma welding machine or weld with a FCAW wire to achieve a lower cost coating.....
Reply




Possibly Related Threads…
Thread Author Replies Views Last Post
Pencil Ball Mill Shaft- Journal Bearing Area HVOF Coating Issue tobjung 0 745 02-02-2023, 06:44 PM
Last Post: tobjung
Lightbulb Plate Rolling / Roll bending Roller worn gerdogan 1 649 12-02-2022, 07:53 PM
Last Post: Vadim Verlotski
  About electrodeposition of Ni-Cr particle on steel plate Catherine 0 3,309 06-06-2013, 04:05 AM
Last Post: Catherine
  Tinning mill rolls shantanu 1 3,211 03-23-2013, 07:45 PM
Last Post: loriolo
  Steel Mill aplication arlen.nurlan 5 6,774 07-29-2010, 05:47 AM
Last Post: Jaydev
  Question on Spreader and Suction Plate kc77 2 5,297 04-25-2009, 12:28 PM
Last Post: Gordon
  Babbitt Cement Mill Bearings Bagri 3 8,889 04-14-2008, 05:59 PM
Last Post: Vijay Deshpande
  Hot Rolling Mill Rolls Vijay Deshpande 3 8,269 02-20-2007, 09:33 PM
Last Post: bhellman



Users browsing this thread: 1 Guest(s)





Surface Engineering Forum Sponsor - Alphatek Hyperformance Coatings Ltd