Posted by ram chattopadhyay (202.177.166.242) on 07:25:06 11/09/05
In Reply to:mains parameters in Thermal spray process posted by Hernando Pacheco
: Hello
: I´m researching about thermal spray process and I´d like to know what is the more important parameter to get a good coat?
: I am new to this so I really could use some advice.
: I am using a TheroDyn System 2000.
: Any help would be much appreciated.
: Thank you, Jim M
Hi,
you can ask the toch supplier or check with any of the text book related to the subject including my book -->Advanced Thermally Assisted Surface Engineering Processes",Kluwer Academic Publishings, MA, 2004.As a matter of fact you need a rough grit blasted surface with surgical cleanliness.Your fingerprints can cause problem of coating adherence.With low thermal thermal capacity torch you are using you have to extra cautious.
ram chattopadhyay
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.
