Gordon England Surface Engineering Forum

mains parameters in Thermal spray process

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Hernando Pacheco (168.176.197.50) on 22:20:37 06/09/05

Hello
I´m researching about thermal spray process and I´d like to know what is the more important parameter to get a good coat?
I am new to this so I really could use some advice.
I am using a TheroDyn System 2000.
Any help would be much appreciated.
Thank you, Jim M

Follow Ups:

Re: mains parameters in Thermal spray process - ram chattopadhyay 07:25:06 11/09/05(0)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.