Posted by Gordon England (62.252.0.12) on 15:37:18 08/08/05
In Reply to: Re: Amdry 6420-Cr2O3 powder posted by Gordon England
: : With 9MB plasma gun,pure Cr2O3 powder,we have below problem;
: :
: : the particles are not getting hot enough so they are bouncing off.
: :
: : Any advice?
:
: Generally, chromium oxide powders do not give good deposit efficiency at the best of times.
:
: Check powder is suitable for spraying at your given parameters.
:
: What is the powder and the 9MB spraying parameters you are using to spray coatings?
:
: Regards Gordon
Sorry, did'nt notice Amdry 6420 in subject line. What 9MB parameters are you using to spray this material?
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.