Gordon England Surface Engineering Forum

Re: ARC spray techniques

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Gordon England (62.252.0.12) on 11:02:14 28/06/05

In Reply to: Re: ARC spray techniques posted by Melvin

Melvin

10 micrometre is not a practical thickness for arc spray coatings. 50 micrometre or more is needed to provide a complete coating. The spray particles produce from the arc gun are usually much larger than 10 micrometre!

Regards Gordon

Follow Ups:

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.