Posted by Jim Mamaril (67.160.89.51) on 05:14:19 30/05/05
I am trying to understand how diferrent size powders affect the relationships of powder feed rates and barrel lentghs.as well as carrier flow rates. I.E. If you switch from a course powder to a fine powder what changes would need to be made,lower carrier flow? Slower feed rate? I am new to this so I really could use some advice. I am using a JP 5000 and trying different powders that meet the specs required so spray parameters are trial and error. Any help would be much appreciated. Thank you, Jim M
Follow Ups:
Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.