Gordon England Surface Engineering Forum

Hard facing on Brass

[ Surface Engineering Forum ] [ Surface Engineering Message Board Archive ]
[ Surface Engineering Message Board Archive Index ] [ www.gordonengland.co.uk ]

Posted by Yang, Ning (61.61.254.10) on 04:32:30 26/04/05

The welding(not brazing) of copper alloys is usually not so easy as the welding of steel. For the hard facing of copper(or brass)using the thermal spray process, is there any limitations on the choice of process or coating material selection?

Thanks in advance and best regards,

Yang, Ning

Follow Ups:

Re: Hard facing on Brass - Gordon England 14:36:54 26/04/05 (0)

Post A Message!

Please go to the new Surface Engineering Forum as this old message board is a read only archive. Please copy and paste relevant information or link to this page if you wish to reactivate this thread on the new forum.